紫外線透射儀快速指南

紫外線透射儀說明

1.紫外線透射儀是一種用于凝膠成像的紫外線燈箱。

警告：

紫外透射儀能發出強烈的紫外線，紫外線輻射可能對未受保護的眼睛和皮膚造成危險，因此必須采取適當?shù)念A(yù)防措施。必須佩戴紫外線防護眼鏡或紫外線防護面罩。有關紫外線防護眼鏡和紫外線防護面罩的產品信息請聯系XEPU的銷售辦公室。

紫外線透射儀操作說明

1.注意開關布置如上圖所示。確保接通/斷開開關處于斷開位置。

2.將紫外線透射儀電源輸入插入裝置并供電。在檢查是否遵守了安全預防措施之前，不要打開裝置。

3.現在打開裝置，確保開關燈亮起，裝置中的燈均勻點亮。

4.不使用時請關閉設備。

5.如果裝置無法點亮，請檢查電源顯示器是否存在，開/關開關是否處于接通位置。如果沒有發現故障，請聯系xepu的服務部門尋求幫助。

紫外透射儀產品介紹請瀏覽：紫外透射儀

UV Transilluminator Quick Guide

UV Transilluminator Description

1. UV Transilluminator is an ultra violet light box for use in gel imaging.

WARNING: UV radiation can be dangerous for unprotected eyes and skin, therefore,appropriate precautions must be taken. UV protective goggles or a face shield must be worn. Please contact XEPU's sales office for further details and accessories.

UV Transilluminator Operating instructions

1. Note the switch arrangement is as shown in the diagram below. Make sure that the On/Off switch is in the Off position.

2. Plug the mains input to the unit and supply. DO NOT switch the unit on before checking that safety precautions have been observed.

3. Now switch the unit on and ensure the switch lamp illuminates and the lamps in the unit illuminate evenly.

4. Please switch off the unit when not in use.

5. If unit fails to light up, check that the mains display is present, that the On/Off switch is in the On position. If no fault can be found please contact our service department for assistance.

Product Introduction：UV Transilluminators